3 Tips in Cleaning and Maintaining a Healthy Radiator

a mom driving a carA healthy radiator ensures a healthy engine. But your car’s radiator will eventually have some leaks. A repair or soldering service, which can be costly at times, will then have to be scheduled. You can always get a good radiator repair in Salt Lake City, Utah, but to prolong the life of your radiator, you have to take some matters into your hands as well. Here are some examples:

1. Wiped off clean the parts to be soldered

Soldering a leak requires you to clean affected areas of the radiator. Paint and hardened dust material are the usual dirt that needs removal. When cleaning, especially if you’re using a grinder or soldering wire, avoid further injuring the damaged part as the hole may widen. A good cleaning agent to lessen the friction is a brake cleaner or any degreasing fluid.

2. Heat the damaged part first before the rest of the radiator

When using the soldering iron (i.e. must be high wattage, at least 60 watts), heat the damaged areas first. Heat the area until it’s hot enough for the solder and wire to close. Afterward, solder the wire gently into the radiator. The hole must be covered with enough solder to make sure that no opening is visible. This will also help prevent accidental leaks during the repair.

3. Smoothen the soldered area

After soldering, smoothen the parts by using a wheel grinder. If you cannot find a grinder, you can also use a steel brush. Be careful not to flatten the soldered parts. Some people want a leveled soldered area, but that would only thin down the material and may cause leaks in the future.

READ  How to Prevent and Handle Brake Failures

Soldering a leaky radiator is easy, as there are no special recommendations to shut off a leak. But, if the leak is still small and manageable, you can choose to use a sealing agent first.